Adding splash-guards to the Grainfather Connect control box

I've been brewing with a Grainfather G30 system for about four years now, and one thing that has always stood out to me as a design flaw is the lack of protection on the side ventilation fins against liquid ingress.

	Quite a few times, because I'm a clumsy oaf, I've spilled Wort over the control box, and each time I've wondered how I haven't damaged the electronics. I feel like it's only a matter of time before it happens.
	I asked my son, who is an Industrial Product Designer, if he could create a couple of models for me that I could print on my resin 3D printer. I exported them from Chitubox and waited a few hours for the print to complete.
	They printed out really nicely, I used Black Anycubic Water Washable resin for this.
	I used a little PVA glue to hold them in place, then ran a bead of UV resin around the seam and cured it with the UV pen.
	I'm pretty pleased with how this turned out, it should guard against accidental splashes of Wort or Water. I do not think it will stop any heat from dissipating from the unit, so no worries on that count.